Thread: [Script✓] Pewter Guidepost Man Issue
View Single Post
Old May 18th, 2017 (10:28 AM).
KrustyKong's Avatar
KrustyKong KrustyKong is offline
    Join Date: Feb 2016
    Location: California
    Age: 22
    Gender: Male
    Posts: 67
    Originally Posted by tkim View Post
    It's because you're overwriting the bytes and your entry is longer than what that offset holds. raw bytes are actually the bytes shown when you open the ROM with a hex editor and go to the offset. these movement byte entries always end with 0xFE. You'll have to use another offset or do a search in the hex editor, the bytes you want to use and if you can find it, just repoint the offset to the found location.
    I think in this particular case, it would be easier to make the initial script short, then use the Delay command during the next part. How would I go about doing the suggestions you gave in case this comes up again later?
    Also I'm not sure how me adding three bytes to an originally 2 command script raises the total from an expected 5 to 6?
    Reply With Quote